Metered NI-STARTER® has a 1.5" barrel with No charger
NI-STARTER® has a 1.5" barrel with No charger
Our 3800ma NI-STARTER® has a 1.5" barrel and is supplied with an UL Approved 110V AC Charger.
Metered 3800ma NI-STARTER® has a 2.5" barrel and is supplied with an UL Approved 110V AC Charger.
This size of the Nifty Hinge is for all model aircraft installations, gliders, Sport models, 1/4 scale, and high performance.
Metered 3800ma NI-STARTER® with a 2.5" barrel with No charger
The NO-HEAT Solvent activates the adhesive on the back side of film trim and bonds it to the face of the covering material on the model, "without the use of heat".
This remote PlugLock adapter supplies power to your concealed glow plug from a remote location.
This NI-STARTER® has a 1.5" barrel and is supplied with an UL Approved 110V AC Charger.
4.8V 2000ma NiMH 4/5 A with a female 3pin deans for Mcd471 and Mcd472 Pulsed On Board Glow Driver.
The Mark "X" is designed to operate under the control of or behind a power panel with a fuel pump control switch.
This unit is set up for a Twin Cylinder Engine.
NI-STARTER® with a 2.5" barrel. Only
Metered 3800ma NI-STARTER® has a 3.5" barrel and is supplied with an UL Approved 110V AC Charger
The length is the standard 5/8" and come with 12" red Teflon wire.
Now with 5 amps of built in power. Over 1.5 hours of glow power.
Glo-Devils are 1.5V Glow Plugs with high performance Platinum Elements designed to perform longer and better.
The Nifty Plug & Socket Keeper is a great little item that will avoid the accidental disconnection of the servo cable plug and sockets within the model.
NI-STARTER® has a 3.5" barrel. The Battery is a NiMH 3800ma cel
Designed for use with Glo-Fuel, Smoke Fluids, and water.
Charge Adapter Cord for NI-STARTER
A special injection molded nylon hinge designed for use on flaps, spoilers, landing gear doors and many other unique applications. Unit without a control tab
110V American AC charger for the NI-STARTER®
Adapts the 4.8V Pulsed Glow Driver mcd471 and Mcd472 external charge jack to fit your Futaba, JR, HI-TEC, (and others) TX&RX A/C chargers.
With tab for the connection of the servo push rod clevis.
A Spring loaded nylon hinge designed for use on landing gear doors and many other unique applications
4.8V 5000ma NiMH "C" with a female 4pin deans for Mcd473 - Mcd479 Pulsed On Board Glow Driver.
It will both store and protect your glow plugs from tool box damage.
High quality foam tape with an adhesive on one side. It's great for seating wings of aircraft or sealing hatches on model boats etc.
Our FiberGlass Tape is a finely woven glass material especially treated to accept resin into the weave.
Installed temporarily to hold the control surface in place while sanding and shaping is being done.
This unit is set up for a 7 Cylinder Engine
The Nifty Driver is a "captive screw driver" for slotted head screws.
Con-Do-It can make the installation of radio cables, servo cables, air line tubing quick, simple and serviceable.
A pin less hinge with the flexibility and strength that only a poly hinge can
This unit is set up for 2 - Single Cylinder Engines
High quality steel pins with a smooth chrome plating and the sharpest of points.
3800ma NI-STARTER® has a 2.5" barrel and is supplied with an UL Approved 110V AC Charger.
Works with one nose wheel and two side folding wing doors.
Best hinge for any installation where you want the lightest weight CA hinge without giving up the high level of flexibility and strength that you require.
Remote PlugLock adapter supplies power to your concealed glow plug from a remote location
A special injection molded hinge from carbon fiber filled designed for use on flaps, spoilers, landing gear doors and many other unique applications where extra strength is wanted
A Carbon fiber filled Spring loaded nylon hinge designed for use on landing gear doors etc. where extra strength is needed.
Functions as an on/off "in line" battery toggle switch for #Mcd471 & #Mcd472 On-Board Glow Driver units.
4.8V 4000ma NiMH Sub "C" with a female 4pin deans for Mcd473 - Mcd475 Pulsed On Board Glow Driver.
Remote corded 3800ma Metered NI-STARTER® has a 15" cord.
Remote corded 3800ma NI-STARTER® has a 15" cord
This unit is set up for a Single Cylinder Engine.
Designed to fit 1/16" to 5/32" axles and up to 3" diameter wheels.
Works with three Nose door type aircrafts (ie: P38)
Deans 3pin male connector with 12" Red & Black 20ga PVC Wire attached
Nifty Driver is a "captive screw driver" for hex headed screws.
Large Control Horns are 1 1/8" tall and supplied with a pad and 2-56 screws for mounting.
110V American AC charger for the Super Mcd466
allow the servo speed to be adjusted, 2 to 10+ seconds of travel in either direction with no loss of torque.
a pin less hinge with the flexibility and strength that only a poly hinge can offer.
This unit is set up for a 5 Cylinder Engine
High quality foam tape with an adhesive on one side.
Two optional installations available, all the optional parts to do them is included. This Super Clevis is molded from a new material giving extremely smooth operation. 2 per pkg.
Silicone Fuel Line 3/32 id 2ft
Super "X" Silicone, Large (3/32" ID) 25ft Roll
pecial larger size silicone fuel line with a molded probe for use in fueling models
PlugLock® Glow Plug adapters are ideal for modelers wishing to use their power panels to light glow plugs.
Replacement internal pump for Mark X & Super X fuel pumps 6V & 12V.
Deans 4pin male connector with 12" Red & Black 20ga PVC Wire attached.
NI-STARTER® has a 3.5" barrel
It is just great in your field box or on your workbench to prevent the loss of the important small parts.
8" x 4" Folding Propeller. Assembled
Designed to hold over 50 different standard and mid-size servos. Molded from tough, glass filled nylon, the Universal Servo Tray is built to last.
Super "X" Silicone, Large (3/32" ID) 2ft pkg
Tips fit both the power and extension cords.
They are supplied eight per package with mounting screws.
All are supplied with mounting screws.
Supplied with mounting screws
Female Molex pin used on all plug harness kits on all On Board Systems
Replacement 8" x 4" Blades Only.
Complete Steering Arm assembly with the New Super Clevis.
Supplied eight per package with mounting screws.
Male Molex pin used on all plug harness kits on all On Board Systems
Deans 4pin female connector with 12" Red & Black 20ga PVC Wire attached
Allow the servo speed to be adjusted, 2 to 10+ seconds of travel in either direction with no loss of servo torque.
Two each of four types, two double arms, two each of the small, medium, and large single servo arm.
Heavy Duty Hinge designed for the location where you want more performance than a standard model hinge offers
Small (5/64" ID) 2ft package